Husky 575xp For sale

BostonBull · Nov 4, 2006

Like new 575xp. Saw has less than 10 tanks through it. Comes with a 20" .058 B and C. The platic has some minor scratches from being in the bin but otherwise is like new and runs really well.

475 plus shipping.

Max · Nov 7, 2006

Hi BostonBull,

Could you please tell me what the first four numbers of the serial number are ? A friend may be interested.

Thanks.

BostonBull · Nov 7, 2006

I can tell you tomorrow. What do the first four numbers tell you?

Max · Nov 7, 2006

I will PM you, not to cause any adverse issues with the sale.

musch · Nov 9, 2006

Max said:
I will PM you, not to cause any adverse issues with the sale.

See, this message has us all wondering.
What do ya know?

Max · Nov 10, 2006

Sorry about that but I did not want to potentially mess up BostonBulls post.
We know that the early 575's were prone to bearing failure and subsequently
failed/melted causing a rebuild under warranty. I have it on good authority that the serial range to ID the problem bearings were from start of production to the first four numbers of the serial number 05.12-----. Anything after that has the new bearings and should be OK. Turns out Bulls saw is in the
shall we say, the good serial range above the 05.12----- cut off.
I have a 575 myself and was concerned so I looked into it and hounded Husky until I found that out. I am not a dealer or an expert just a guy who wanted to know about his saw and any potential problems the factory had knowledge of. Again Bulls saw is good according to his number!!!!