Anyone have a good lead for a used OEM 357xp piston with the narrower crank saddle? Part number 503920471?
Husqvarna 357xp 13mm piston?
- Thread starter Armosh
- Start date
Help Support Arborist Forum:
Their out there but very hard to find. You may get lucky someday.
GL on 13mm turning up. I know a guy with some but for his own uses and not FS.
Like said in other thread. You can use the 15mm newer one with 13mm wrist pin bearing and thrust washers to take up the little slop.
GL on 13mm turning up. I know a guy with some but for his own uses and not FS.
Like said in other thread. You can use the 15mm newer one with 13mm wrist pin bearing and thrust washers to take up the little slop.
Yeah might end up doing that ultimately. Was worth a shot though. The part number 503920471 is for the older 13mm piston though correct? Because I did find atleast one place that has them in stock. They're about $140 for the piston though.
Yep
Who/where? I might be needing one.
@Armosh there is a guy in my chainsaw repair group FB that has 2 of those FS right now for 100 each plus ship. https://www.facebook.com/groups/415662708518445/
THANKS
Thanks for the tip!
Ended up buying that piston from the guy on FB. Good group too. Thanks for the heads up
