Husqvarna not oiling, help?

[Chainsaw Collectors]

I have a Husqvarna 142 e-series chainsaw. Just installed the new muffler and got it running. Probably needs some carb adjusting as it doesn’t always idle right, occasionally is doggy when trying to get to full throttle, and often dies 4 seconds after chain brake is applied, runs fairly well tho. The problem is I tested the oiling by having it close to a 2x6 at full throttle for a while and no oil at all. Took bar off, cleaned it some, noticed oil you can see in pic on saw in small quantity, same problem. Any ideas?

 

[coffeebrk]

What is the condition of the oil pump worm gear?

 

[Chainsaw Collectors]

What is the condition of the oil pump worm gear?

I’ve never messed with oiler before. How do I go about checking that?

 

[coffeebrk]

Oiler repair

 

[echomeister]

husky bar has a small hole for oil to pass through to go directly to the rails. It clogs up on mine frequently.
Need to remove the bar and clean the bottom of the rail with a pick.

 

[Chainsaw Collectors]

husky bar has a small hole for oil to pass through to go directly to the rails. It clogs up on mine frequently.
Need to remove the bar and clean the bottom of the rail with a pick.

I’ll clean the bar better with a pick like that then. Thanks.

Oiler repair

Good video, thank you, if cleaning with pick don’t work I’ll look at that

 

[Gord404]

if the other problem when you apply the chain brake when it's idleling and it quits you might need a new clutch.