Most broke where the lower stop is molded to the elastomer. It seems like there was no slack in the line between the upper and lower stops. I sent 40 or so back but still have another 10-20 sitting around.
Huztl MS660
- Thread starter Kyler Monares
- Start date
Help Support Arborist Forum:
Most broke where the lower stop is molded to the elastomer. It seems like there was no slack in the line between the upper and lower stops. I sent 40 or so back but still have another 10-20 sitting around.
They should know about it then. The ones on my 440 and 380 are working guess I should slow down on the 660 until I am sure again.
PM me your address and I'll send you a couple to try.
I think I found my problem. It's hard to tell in the picture but the filter is sitting at about a 60 degree angle up the back side of tank.
The bottom of the picture is the verticle side of the tank where the handle is.
Sent from my SAMSUNG-SM-G890A using Tapatalk
The bottom of the picture is the verticle side of the tank where the handle is.
Sent from my SAMSUNG-SM-G890A using Tapatalk
I believe ya. I was talking about speaking up so they could fix it. A 660 pulls fairly hard. That could have something to do with why my two survived.
If your filter which of course is attached to your line was out of place inside your tank when you had your saw on its side while milling that was what I was referring to. As your tank of fuel depletes it can suck air and cause problems. Easy to happen on a new build.It appears my fuel line is oriented in the handle correctly. Next step is to look I the tank.
Sent from my SAMSUNG-SM-G890A using Tapatalk
So keeping that tank full as possible is good insurance
That's itI think I found my problem. It's hard to tell in the picture but the filter is sitting at about a 60 degree angle up the back side of tank.
The bottom of the picture is the verticle side of the tank where the handle is.
Sent from my SAMSUNG-SM-G890A using Tapatalk
Yep I just posted a picture of my filter showing exactly what you explained. Lol. I will have to get it fixed before I mess the saw up to bad. But first I'm pressure/vac testing it tomorrow hopefully. My mityvac is suppose to be here tomorrow
Sent from my SAMSUNG-SM-G890A using Tapatalk
I have another saw that's getting tested soon. Lol
Sent from my SAMSUNG-SM-G890A using Tapatalk
Sorry for the slow response. Here's a side-by-side comparison. That's a Huztl on the left, Hyway in the middle and OEM on the right. All new from the package.
Dang that nails it. I will just order an oem. I have a farmertec installed. I just finished my new 660. I can wait a bit longer. That was very helpful for us all on the. Poof's in the pudding.
The wrap handle requires 3 hands and a rubber hammer to install. It got slightly out of whack on the ride over. But it's right now. A reminder when buying the huztl brake handle you do not need to buy a different brake handle theirs is the one you need, got the right slant.
Similar threads
Withdrawn
Stihl ms460 mag
