I don't think the 346 and 550 will line up. The 562 ones are real close. I'm ready for the 372 set. The 084/088 are the same inner and outer. You just need one to get a pattern from.
Making some 044, 064, 066 Dogs. . .
- Thread starter Metals406
- Start date
Help Support Arborist Forum:
I don't think the 346 and 550 will line up. The 562 ones are real close. I'm ready for the 372 set. The 084/088 are the same inner and outer. You just need one to get a pattern from.
Tractorsaw1
ArboristSite Guru
I need an 064 set also, send me the payment/run info, Thanks!
Naked Arborist
Hack from way back.
Randy MM has Phils 88, I think.
Its already back to him. If. Was home I would scan my eBay specials I bought to tide me over.
I just sent him some 088 dawgs yesterday, should be there thursday!!!
Do you have any pictures of the 372xp and 385xp dawgs???
Metals406
Granfodder Runningsaw
Pete, not on my phone. I can take some later.
Nate I'm ready for 2 sets of 372 spikes if you have them cut.
Metals406
Granfodder Runningsaw
Sounds good Mike. . . I'll be cutting some soon. I got a huge project brewing. Exciting!
Just let me know. I've got a good list of what I need.
Metals406
Granfodder Runningsaw
Got Pete's 088 dogs for mockup and templating. Them babies are thick!
Great, yep them are biggies. The one may be bent just a little, I know it was a little tweeked when I sent it, so wasn't the post office.
Eccentric
Mister Wizard
So Nate.......................................any progress on the 2-series Husky dogs???
opcorn:
opcorn:
Metals406
Granfodder Runningsaw
Yes and no. I was up there at a BBQ and might have talked him into letting me template. I also looked closer at a few of them.So Nate.......................................any progress on the 2-series Husky dogs???
There was one 2100, a couple 262's, a possible 181? A couple I couldn't quite nail down. I don't have chainsaw ID superpowers like you and JJ.
Eccentric
Mister Wizard
That just leaves the 61-272 series. You've got the 285-2101 series, 257-262 series, and 181-288 series there.
jughead500
Sasquatch
Any way you could cut some wildazz long dawgs for my echo cs600? When stumpin' with it the spikes on the stock dawgs sometimes just arent long enough.
They are identical so you only need one. Good deal on the others Nate.
Metals406
Granfodder Runningsaw
Not really pard, it'd be a pain in the butt on my end. You're better off drawing up what you need and having it cut locally.
jughead500
Sasquatch
Ok thought I would ask.the stock dawgs on the echo just arent long enough sometimes.especially on maples.
Metals406
Granfodder Runningsaw
I feel ya. Templating isn't too hard if you have the stock dawgz on hand. Take them off and trace the rear mounting area of the dawg on some posterboard. Then draw the spike shapes you want on the front, making sure they like up when mounted on the saw. Take them to a local shop with a laser, plasma, or waterjet table.
