McCulloch Chain Saws

Garrettlsx · Tuesday at 10:29 AM

If anyone on here has any mcculloch 99 parts saws or just parts and wanting to part with them i would be interested. I am needing carb parts/assembly, recoil, possibly a throttle cable, points cover, and everything between the recoil and the flywheel its self. I have attached pics of the saw i am working on. Thanks ahead of time, Garrett.

heimannm · Tuesday at 8:23 PM

I had to get something out of the utility closet today and remembered I'd put the PM700 in there to allow the Red Cote to fully cure (warmer in the closet...).

Fueled it, started in 3 or 4 pulls and only needed a little tweaking of the H screw. Automatic oiler works very well.

Mark

Max the Mac Man · 2025-02-19T08:35:21-0500

heimannm said:
There are some parts that will interchange on some models, but it is a lot more complicated than your might think.

Some crankshafts, some connecting rods, probably some pistons are the same. The crankshaft seals and mufflers (with some exceptions...) will interchange. The starter rope and handles will interchange...

The cylinder and crankcase for the PM 6 models is distinctly different from the Mini Mac models.

The flywheel will interchange on early models, ignition coils and condensers are the same...

The starter pulleys are even different, the PM6 are smaller in diameter and the hole in the center is smaller.

They both use MDC carburetors but the fuel inlets are different, and the choke shaft is different so you even swap the carburetors (after changing the fuel inlet portion).

Mark

"There are some parts that will interchange on some models, but it is a lot more complicated than your might think."

Mark, Truer words were never spoken!