dsell
Addicted to ArboristSite
My bearing is at the end of life on my chain spinner, #7. Does anyone have a photo of a new bearing? I'm trying to determine if it's worth spending the $50. I tore it apart last night and it was my worst nightmare putting it back together. I cleaned the 18 needles and the cage, and the nightmare was putting the needles back together. I greased it good and it sounds good when spinning, but the cage is nearly toast. There was bits and pieces of metal inside, so I'm not certain what it should look like. If the bearing race is not part of the bearing and is actually the alloy metal base, then I doubt it's worth doing. Below are the new numbers, the old were 108784Si for the anvil drive bearing, 108785Si thrust bearing, and 108786Si thrust washer. I'm not sure I understand what 108785Si thrust bearing was on the old parts because mine only has one bearing which is shown as #7. Maybe I have a different model.



