That makes sense since you're pulling cars in and out on a normal basis. I would think most times I was going to pull something in it would be one of three scenarios. One it would go on the lift, and would be a bit higher where it would get warmed a bit quicker with radiant heat and the air up there should be a bit warmer. Two it was getting pulled in to work on it real quick, and we were just needing it out of the weather. Three would be it's coming in, but can wait a bit so it will be warmed up by the time we get to it.
For the tractors they would just go out to work outside a bit, then come back in for quite a while, so not a big deal.
Would have been nice to have natural gas here. Every street that is connected to ours, and the end of it has it, and our tree isn't but maybe 1.5 miles long
. That being said, I wouldn't know any of you fine fellers if we had natural gas
and we wouldn't even be having this conversation lol.
Your propane is cheap compared to here, that would certainly be a factor to consider, maybe Trumps policies will get it down a bit
.
Yeah, it's only for temporary. I have an actual furnace that I'll probably install, already bought it for $100 bucks last summer, it's a high-efficiency power vent style. But I'm not sure it's the best route or one source would be a good idea. The good thing is we have a great power company that's local (literally 1.25 miles NNW from here as the crow flies), and we don't often have outages, so I shouldn't need a wood stove. I've considered an electric water heater set-up for the 12x24 saw shop area, be nice not to have any penetrations thru the walls or the ceiling. I have the wainscoting on the barn, so if I was to install a small mini-split in that area I could go thru down low. It would be sweet to have AC in there. I'd also want at least one good sized electric baseboard heater to use if it was too cold for the mini to work.
Oh snap, can we use the skidding winch
.
At least the sap will be frozen, so my saws won't get dirty with sap.
One of those would work for my 12x24 shop, but I don't want to support the CCP and I don't want to make the holes in the walls ceiling if I don't have to. The semi I drive has one for the bunk heater, I run it whenever it's cold out, then I only need a little added heat from the trucks heater. It's nice not to have the fan blowing air in you eyes and drying them out, or hot air on the windshield to heat it up and make the snow stick to it, even though I do have heated wipers(hate to use wipers unless I have to). One nice things about those little heaters, is you can get them with a controller. It would be nice to just click the temp up from the house(if it reached), or from the car when you pull in from work.
42 isn't terrible, I'm shooting for 50, then being able to warm it up a bit more if I'm out there.
The propane companies here all give me, and others I've talked to, a hard time about filling the 24 gallon/ 100lb tanks. I'm almost as big of a fan of propane companies as I am rust or Chyna.
Ouch.
Is electric pretty expensive there, ours isn't bad compared to the bigger companies in MI. That being said, I hate paying for it.