Sure is quiet in here....do I need to start a fight?

[Stihl 041S]

I have a life jacket..........in brothers ski boat

Sent from my SM-G930V using Tapatalk

I'll stop by next time I visit Der Slug.

 

[farrell]

I'll stop by next time I visit Der Slug.

Kinda out of the way

Take the long scenic route to johns!

Sent from my SM-G930V using Tapatalk

 

[Stihl 041S]

Kinda out of the way

Take the long scenic route to johns!

Sent from my SM-G930V using Tapatalk

I'll stop by Cleveland and count the dead fish and beer cans

 

[farrell]

I'll stop by Cleveland and count the dead fish and beer cans

May be there awhile..............

Go to where the ducks walk on the carp

Sent from my SM-G930V using Tapatalk

 

[Stihl 041S]

I dont care what that slug says bout you............your a stand up guy!

Your welcome here anytime

Sent from my SM-G930V using Tapatalk

You have very low standards.......

 

[farrell]

You have very low standards.......

It happens

Sent from my SM-G930V using Tapatalk

 

[pioneerguy600]

Canoes are a great mode of over water transport. I have logged thousands of miles travelling solo in canoes since first stepping into one back around 1958.

 

[dancan]

Yup

Dirty Flippycap saw.

Mighty Mouse Logging LLC

 

[pioneerguy600]

My saw is dirtier than yours, it will get a cleanup this week.

 

[dancan]

 

[dancan]

My saw is dirtier than yours, it will get a cleanup this week.

I spray mine down with pam , slides through the wood faster and the pitch and gum doesn't stick to it , makes it a couple of degrees cooler as well .

 

[Jimmy in NC]

I grabbed my go to saw yesterday to cut the last few trees of the hurricane I am dealing with that were on a storage building at the rental. It fired right up and I looked down and started laughing...no paint on that bar. Its a cheap Oregon 24" that I have had for years. Been dressed a few times and generally taken care of but seen lots of trees. Apparently I was doing it right with out taking temperature readings and all.

 

[tbone75]

WOW !!! Busy over here fer a change !!!

 

[pioneerguy600]

You should have shown a side on pict, that saw is a sticky dirty mess, front on also shows a lot of sap buildup.

 

[dancan]

You should have shown a side on pict, that saw is a sticky dirty mess, front on also shows a lot of sap buildup.

But the bar stayed clean after the AmourAll test so it would just slice through with no friction keeping the temps down , now we know how well that works
Might even have to run thinner bar oil it ran so cool .

 

[dancan]

Here's a Mighty Mouse LLC vid of the Mighty Mouse 026 gettin it done , felling against the wind .

 

[Stihl 041S]

And real close to the wood pile!!!!

 

[dancan]

Yup , right on target lol

 

[Cantdog]

So, Dan, what do you do with all that spruce....furnace wood? Try to mill it into 2X's? Sell it for pulp or biomass?

 

[nenicu]

Hello from a Ryobi fan. What's the story with your Ryobi Dancan?. Thanks.