Swap meet...

[lwn9186]

What's with this run on 250 parts?!

Over priced cheap saw!

 

[richard t]

Remington sl-4 pull rope broken turned over by crank seems to have good compression. Never ran it just looking to weed out some saws. Would trade for husky 288 parts or husky 41 parts

I really don't need another project saw. but what parts do you need for the 41

 

[sefh3]

What's with this run on 250 parts?!

One of the best homeowner saw you can buy.

 

[tbone75]

One of the best homeowner saw you can buy.

Nah , Husky 350 is !!

 

[moody]

Nah , Husky 350 is !!

+1

 

[sefh3]

Nah , Husky 350 is !!

I was waiting for that.

 

[tbone75]

I was waiting for that.

You knew I would do it ! LOL

 

[Stihl Livin]

Anyone have a scabbard for a jonsered 2153 with a 16 inch bar they are willing to part with.

 

[lwn9186]

MS250 in need of a top handle housing and clutch cover (without quick chain adjuster). Thanks

Please

 

[shawn022]

Does anyone have a fuel pump cover for a stihl 066/660 ? Its the one with the impulse fitting. Carb is a walbro wj-35

If no one has one, could someone give me a part number for one? Thanks

 

[psuiewalsh]

Does anyone have a fuel pump cover for a stihl 066/660 ? Its the one with the impulse fitting. Carb is a walbro wj-35

If no one has one, could someone give me a part number for one? Thanks

I have one should work, and put it in your box.

 

[psuiewalsh]

Looking for some husky 395 parts. I need a good blue kill wire, intake boot and bare or whole clutch cover and some stop screws 5037493-01. Have stuff to trade or some funds trade.

 

[shawn022]

I have one should work, and put it in your box.

Perfect, thank you.

 

[caddguy]

Looking for following Husq 2100 parts:
Fuel line, tank vent assembly and good fuel cap seal ring.

 

[epicklein22]

Looking for a good 044/046 clutch. Little to no wear to the clutch spring holes ideal.

 

[lumberjackchef]

anybody got a brake handle for a 391?

 

[Detroit Dazzler]

I really don't need another project saw. but what parts do you need for the 41

A grey top cover would work or the plastic bottom of the saw where the jug bolts

 

[Modifiedmark]

Anyone got 118 DL of 3/8's .050 gauge skip chain they want to trade or sell me? Or by chance I could use .050 gauge .404!

I don't feel like ordering one chain if you know what I mean.

 

[psuiewalsh]

Anyone got 118 DL of 3/8's .050 gauge skip chain they want to trade or sell me? Or by chance I could use .050 gauge .404!

I don't feel like ordering one chain if you know what I mean.

I have some 3/8 50 skip loops in 28" if you want to combine. They are used. I prob have enough 404 50 loops to make one but not skip.

 

[tbone75]

Looking for a complete clutch cover for a J-Red 820 , muffler with bolts , bar and bar nuts. I know its a tough one. LOL
Got lots to trade !

Also need a wrap for my 2065 J-Red , Husky wraps don't fit.