What do you take to the woods?

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
I cut on my own property and my neighbors property so usually the gear goes on the back of my Arctic Cat TRV (has a big plastic box).
- 3 saws (40,50,70ccs usually), if I know I'm dealing with bigger stuff that day the 60 and 90 find their way in place of others
- gas/oil (gallon of each)
- small chainsaw toolbox with files, screwdrivers, sockets/scrench etc...
-chaps/earplugs/helmet/gloves
-small axe, 3 plastic wedges
-small first aid pack (stays on the quad always and includes some maxi pads to stop bleeding)
-Yeti of coffee, jug water
-4x6 trailer follows the quad
If I use up a gallon of fuel I'm done for the day.
 
These days I take an 018, MS260, and a 066. Everything under 8" diameter (approx.) I cut with the 018. Then I fire up the MS260 to cut all the stuff up to 18". Finally, I get out the 066 to cut up the big stuff. Last tree I cut up was 36" at the base. I put 2 heaping full loads of wood on my Dad's 7'x14'x2' high GN dump trailer and still had to fill my empty pickup truck bed stacked up to level with the top of the cab on my last trip in order to get that tree hauled to the house! I always take 3 chains per saw, my scrench, tuning screwdriver, mixed gas, chain oil, and a cooler full of iced down bottled waters. This usually keeps me running all day long!!!
Its' funny how that little 018 runs and cuts so good. It gets me thinking that it is my fastest saw....and then I fire up the 260 and it changes my mind...and then I grab that 066...what a monster of a power house!!! Each saw works best in its particular use. I would never consider trimming limbs with the 066...too heavy. I used to be a one-saw guy...and the MS260 did the job quite well. Only problem I ever had was when I tried to cut stuff the 18" bar wouldn't reach through after cutting both sides. The 066 solved that problem. 28" bar (and a 42" bar hanging on the shop wall just in case)
 
I got to much crap to take everything. 1 or both saws, an axe, fuel/oil, wedges, PPE about covers it. If I am after something I spied on an earlier trip then the appropriate crap gets loaded.
 
something I have noticed folks to the north say property I call it land here in VA , 3 saws, gas and oil , beans , nabs, drinks, water , tools , chains, axe maul and wedges
 
I cut on my own property and my neighbors property so usually the gear goes on the back of my Arctic Cat TRV (has a big plastic box).
- 3 saws (40,50,70ccs usually), if I know I'm dealing with bigger stuff that day the 60 and 90 find their way in place of others
- gas/oil (gallon of each)
- small chainsaw toolbox with files, screwdrivers, sockets/scrench etc...
-chaps/earplugs/helmet/gloves
-small axe, 3 plastic wedges
-small first aid pack (stays on the quad always and includes some maxi pads to stop bleeding)
-Yeti of coffee, jug water
-4x6 trailer follows the quad
If I use up a gallon of fuel I'm done for the day.

A gallon of mix in a day is some serious cutting.....but I'm to old to run a saw all day. Lol
 
Cant hook or peevee. Logs need to be rolled

I can honestly say I don’t even own
a cant hook. I probably should have one as it might save me a chain here or there. When there is no snow I’m cutting already fallen ash. Once the snow hits I start falling dead ash or elm which ends up somewhat supported by the snow.


Sent from my iPad using Tapatalk
 
So I’m curious what everyone else takes to the Woods for an afternoon or weekend of cutting firewood?

I take three chainsaws, MS210, MS362, & MS660. I take no files or extra chains but only a carburetor adjusting screw driver and a bar wrench. Gas, bar oil as well as my PPE gear are also included. I haul 100% of the wood with my John Deere gator. I cut 90% of my firewood with my MS210, once the chain gets dull I go to the next saw.

It takes me a minimum of three loads as pictured below to get through one week of heating both my house and my shop. Four loads once the temps drop into the teens or below. I have no idea how to judge a cord of wood. Maybe somebody viewing the picture could give me an idea how much is on the Gator?

Just wondering how everybody else does it?
2dbbc6c2028730a86f9c226b3b13d8a8.jpg
d664b5379dd9f0e8a78600ca97135199.jpg



Sent from my iPhone using Tapatalk
I would be worried about that pile of logs falling on me while driving that load.
 
When I was in the woods cutting firewood, all I had was a Poulan SD25. I took it, spare chains, gas and oil along with an axe. Now I usually cut on someone's land where I am close enough to civilization to be safe. I carry my 3 saws, box with chains and tools, 2.5 gallons of gas and a gallon of bar oil. Also bring along a come along and tow chain.
 
When I was in the woods cutting firewood, all I had was a Poulan SD25. I took it, spare chains, gas and oil along with an axe. Now I usually cut on someone's land where I am close enough to civilization to be safe. I carry my 3 saws, box with chains and tools, 2.5 gallons of gas and a gallon of bar oil. Also bring along a come along and tow chain.
Sounds like what my dad did back in the day.

Steve
 
Hatchet, swiss army knife, duck tape, take-down mini fishin pole, a tarp and some rope and some tyvek, space blanket, mini pillow, 1377 and some pellets, mess kit, Benadryl, water, lighter..?
Oh yeah, and some toilet paper.
 
I'm surprised more people don't take a firearm with them. Mine goes on after my wallet daily.

I agree

Absolutely every single place i am i have at least one fierarm on me with a spare mag. I avoid “pistol free zones” at all cost.

I even turned down jobs before if the employer didn’t let me carry.






Sent from my iPhone using Tapatalk
 

Latest posts

Back
Top