Looks pretty damn good Brad.
Very nice job.
You just need to get the rubber
spark plug cover.
Lee
Look at this pic.
One of these 1130's has the cover.
It's the same cover for your 1050
Lee
Look at this pic.
One of these 1130's has the cover.
It's the same cover for your 1050
Lee
All the 1130's and 1050's had them.
The older 1020's, 1100's and 1000's
did not have them. Most users when
had to change a plug through the cover
out in woods.
Lee
Looks like PN 63735-A. None on eBay. I could use two of them.
You better check ebay for stuff like that atleast 10 times a day if you plan on pulling the wool over my eyes!
Is that a challenge? Let's see who can get one first BTW, I got my throttle grommet today and it was in nice supple condition. Not gooey at all.
WooHoo!!! The clutch cover is very close in color, but the muffler cover is off quite a bit. I'm going to go ahead and paint them both for a perfect match. Then it will be time for decals. I may also replace the handlebar. At a minimum, it will be getting a new covering on the tubing.
You haven't put those decals on yet?
Is that a challenge? Let's see who can get one first ..............
Enter your email address to join: