I wanted to use the Oregon DuraCut Chain on my NEW CS-4910, however, it only comes in .058 gauge (and larger), and my 4910 uses .050 gauge.
Is it possible to place a .058 bar on my 4910 and run that chain, or will it fail to connect properly with the rear clutch/sprocket. If not, can I replace the rear clutch/sprocket so I may use .058?
I have allot of 'smaller' dirty fallen trees, and know the current offerings of chains for my 4910 will be quickly destroyed, and the diamond variety is ridiculously expensive and impractical.
CURRENT
Oregon Control Cut
18" .325 .050 72DL
DESIRE
M21BPX072G Duracut
18" .325 .058 72DL
Is it possible to place a .058 bar on my 4910 and run that chain, or will it fail to connect properly with the rear clutch/sprocket. If not, can I replace the rear clutch/sprocket so I may use .058?
I have allot of 'smaller' dirty fallen trees, and know the current offerings of chains for my 4910 will be quickly destroyed, and the diamond variety is ridiculously expensive and impractical.
CURRENT
Oregon Control Cut
18" .325 .050 72DL
DESIRE
M21BPX072G Duracut
18" .325 .058 72DL