Yamalube 2R (8.5 viscosity) and 800 off-road is (15.5 viscosity at 100C). Going from 8.5 to 15.5 is an 82% increase. Translate the percent difference to whatever ratio you want for a comparison. Pretty easy.I am not following you how you make the jump from viscosity to oil ratio..
I think your logic that a increase in viscosity allows you to use less oil flawed, but your welcome to try it on your equipement.Yamalube 2R (8.5 viscosity) and 800 off-road is (15.5 viscosity at 100C). Going from 8.5 to 15.5 is an 82% increase. Translate the percent difference to whatever ratio you want for a comparison. Pretty easy.
Sounds right! Where at?Is $10.99 a quart for Yamalube expensive?
13.94 per l at my local shopK&W Cycle....2 miles from my house
http://www.kwcycle.com/Yamaha-YAMAL...-OIL-detail.htm?productId=18325485&ez=&pos=12
Yeah i see that now, the Yamaha site didn't say thatInjector oil
They typically are pretty thin.
Why do you perfer semi syn???I seem to like using semi-synthetic oil better than full synthetic.....so how bout Yamalube 2S $30.99 a gallon.
I would not use 2S in a saw.I seem to like using semi-synthetic oil better than full synthetic.....so how bout Yamalube 2S $30.99 a gallon.
Its about balance.. Too thick and it combusts like crap. Too thin and it doesn't lubricate as well.Thin = bad ? Or too thin = bad?
Its about balance.. too thcik and it combusts like crap. Too thin and it doesnt lubricate as well.
Enter your email address to join: