Bar Scabbard suggestions

[two4spooky]

I use 550 cord for the loose or odd fit. Drill a hole at the open end, side seems to work best

Posted these before. I mentioned the ‘tethers’ on the pole saws, if concerned about them falling off.

Philbert

View attachment 1213467
View attachment 1213466
View attachment 1213465
View attachment 1213464
View attachment 1213463

. A slip knot or plastic sliders does it. Loop to what ever is convenient.

 

[two4spooky]

But those canvas and leather deals do look nice

 

[Joe Crow]

Pictures please.

Pictures of home made aluminum liner please

 

[Trailsawyer]

I think that this has always been required for wildland fire fighters who carry the saw on their shoulders. I am not sure that this would apply to volunteers who don't carry the saw on their shoulders.

We were told that the reg applies to all who are working on FS projects. One of our crew members actually purchased a "approved" cover -- for over $200! It is one that is being used by wildland firefighters, but I'll have to find out who makes it, and sells it!

 

[PV Hiker]

Been using and pleased with TrueNorth covers over the years carring saws for trail work. Have a pad for shoulder and cover the dogs. The rubber can rest against the hot muffler fine. Our trail organization also uses them.

 

[PV Hiker]

TrueNorth There is also pockets that I keep scrench and 2 or 3 chains and maybe cloth small brush. For older saws carry bar nuts e-clips.

 

[Nazjaz]

better pic for ya.

I cut this one to cover the dogs.

View attachment 1213915View attachment 1213916

Nice! what width is that hose (top to bottom) ?

 

[ZeroJunk]

And, I am wondering what you are doing with a saw that you need a scabbard on the chain.
Lay it on the clutch cover and put a rag over the tip..

Or, change whatever it is stupid you are doing.

 

[flatsfisher]

Nice! what width is that hose (top to bottom) ?

5" flat.

 

[Trailsawyer]

And, I am wondering what you are doing with a saw that you need a scabbard on the chain.
Lay it on the clutch cover and put a rag over the tip..

Or, change whatever it is stupid you are doing.

I suppose that volunteering to clear 60+ miles of horse/hiker trails every year on our local National Forest might seem stupid to some people.......especially when most of it involves carrying all of your own gear! A "sawyer" and a "swamper" normally pack a saw, axe & wedges, gas, oil, spare chain and small parts, chaps, hard hat, ear protection, 2-way radio, emergency first aid supplies, and your lunch! Some days you can cover 5 miles, some days you might only clear 100 yards! Oh.... the "easy way" to carry a saw is over your shoulder! A scabbard just makes it a little safer!

 

[Philbert]

Or: when working in complex situations, among other people; protecting the saw / vehicle / etc., during transport; carrying the saw through brushy conditions; carrying long bar saws when chain is vey sharp; etc., etc., etc., . . .

Philbert

 

[Bob Hedgecutter]

Or: when carrying saws in the back bed of an SUV whilst also carting a dog or two in the same cargo space......

 

[Philbert]

Or: when carrying saws in the back bed of an SUV whilst also carting a dog or two in the same cargo space......

!Is that why the scabbard must cover the dawgs?’

Philbert

 

[Bob Hedgecutter]

!Is that why the scabbard must cover the dawgs?’

Philbert

No laws about that here yet- but dog feet and saw chain don't play well together.
Mind you, I have personally seen a logger trip with a saw bar over the shoulder, chain rash to holding hand and side of neck- 3 puncture wounds to back of shoulder/collar bone region- so I can see why it might be considered prudent to have dawgs covered and worry about dog feet later.