People, in general, need to wean themselves from buying Chinese stuff just because it's cheaper than brand name equipment. I look at it this way... Trump will fix that issue with tarriff's that will increase that cost, substantially.
Farmertec Warning
- Thread starter JoeSawz
- Start date
Help Support Arborist Forum:
No, they would just have to buy dollars first. Oil is almost exclusively traded in dollars for instance.
Good response.
The other thing is the fact you have a limited time for break in to occur. You go past that time period and the engine never properly breaks in. IE the rings never seat properly.
Warm it up and get it eat full throttle.
Cylinders glazing sucks to deal with. Fourtatnly I haven't dealt with it in many years.
I did that to myself with my Honda generator. Bought it new for an ice storm, and it basically idled the next 6 days, only revving up when the freezer compressor kicked on. Had a lot of other things going on, didn't even think about doing proper break in. Runs reliably, but runs like crap. Plug gets dirty, pings at low loads, blows blue smoke when throttling up, oil gets dirty fast, all the things you'd expect from improper ring seal. No clue how much less life the engine will have because of this. Hear about these things going crazy long hours but no way this one will.
Last few times I've run it have been for 4+ hours at near full load charging batteries, and that seems to be helping. Ideally I'd tear it down, hone new cross hatch in the cylinder, put new rings in it, and break it in again properly.
Properly break in your stuff, folks. You only get one shot.
Generators all have the same problem. Even with proper break in they run unloaded so long that alot of fuel gets into the oil, the plugs run dirty and eventually the rings wear prematurely to the point they burn oil.
That's been one unintended bonus of the solar power system and large battery bank. During winter in this area solar basically does nothing, so power outages are handled by generator. Now instead of idling 24/7 and reving up here and there, the generator runs at nearly full output for a few hours one day, and then not at all for a couple days. Lot better all the way around.
we load banked tons of generators at the shop. Usually big diesels, slobber the exhaust up to the point you'd have to take it off and burn it out, or replace it. Few times you could get them hot enough with the load bank to burn themselves out. They never lasted as long as generators that had built in load banks or were loaded heavily, regularly. All the running with no load to make sure they run is pure bs.
More or less same thing applies to small gas/gaseous generators. Although they usually break in very quickly vs diesel powered generators.
I've never personally seen someone recover a fully glazed cylinder without disassembly and new rings, so I would think performance and longevity would be greatly decreased.
More or less same thing applies to small gas/gaseous generators. Although they usually break in very quickly vs diesel powered generators.
I've never personally seen someone recover a fully glazed cylinder without disassembly and new rings, so I would think performance and longevity would be greatly decreased.
When the cross hatch is folded over you won't ever break it in.
