McCulloch Chain Saws

[JSMississippi]

After realizing I built up the wrong bp1, I now have built a model matching the January ipl. She breathed fire last night after some help from Parker Jameson. I was using a Sig-01 ignition chip and Parker suggested a Nova2 due to the polarity of the Flywheel magnets being not very consistent and the ability to just flip the wires on the nova chip.

I wanted to show off ,as we all do when we're proud of our accomplishments, and show some of the literature I have acquired since learning about these saws. That spec sheet is the absolute coolest things imo.

Also shown in the last picture is the bp1 I have rebuilt as stated matching the January of 62 ipl, beside it is the bp1 from Mark Garris that appears to match the October of 62 ipl, subtle differences in the 2 if you look closely. More pictures side by side will be shown once the October model is rebuilt in the coming weeks.

Yall have a good weekend its time for me to make wood chips

I take it these photos are the culmination of a LOT of effort! Very impressive.

Really like the font of the embossed McCulloch on the sides!

 

[Rotax Steve]

Steve, I think I’ve read somewhere that cleaning them in a fuel mix bath or just gasoline is acceptable. Hopefully others will confirm.

Thanks JSMississippi - I'll await more input.

 

[Rotax Steve]

More questions
1 - Swapping out the flywheel and cleaning and wanted to know if my assumption that this is excess seal that squirted out and I shouldn't worry about the crank seal?
2 - What is this for? A thick cable (1/4") from the lower AV mount (also not found in the IPL) to the lower brace.
3a and 3b - The IPL I have is from Leon's Chainsaw Parts and Repair and the model numbers match the tag on my saw. Any thoughts?
Thanks everyone!

 

[Squareground3691]

Got this one today, nice shape 850 , clean piston and cylinder 160 psi , should be a good runner ,

 

[heimannm]

Steve - 1) That is just some excess silicone from assembly 2) The wire is the ground wire that would normally run from the center of the top/front mount on the oil tank to one leg of the front mount at the fuel tank to provide a ground for the kill switch. That is an interesting alternative solution. 3) As has been noted, your saw has been put together from different bit and pieces, the fuel tank at least came from an SP81. Not everything is original or in the original location.

Squareground, you will find the performace of that saw is pretty impressive. I think a PM850 in good condition is the best of the 82cc models.

Mark