47mm=54cc, 49mm=60cc sounds like a 3450 p/c
Nik's Poulan Thread
- Thread starter FATGUY
- Start date
Help Support Arborist Forum:
47mm=54cc, 49mm=60cc sounds like a 3450 p/c
Not sure if my chart is right but its showing a 46mm bore for those 54cc saws. My chart also list them at 53cc so your probably right and its wrong.
Never the less if it looks just like a 3600 but is a smaller bore with a chrome piston and a bare bore then I would have to say its a 3350. The one I have never seen before in person and wondered if it was more of a export saw.
Al, let me ask, does it have a different muffler also?
For Roger...
Done
That was my best swag, so I concede that you are more correct than I.....
I have yet to see a 3600 or 3350. But it sounds like a 3350 with unplated top end with chromed piston like a 3.3 or 3300 54cc
Thinking the measurement is 46.5mm
Done
That saw looks very familiar and if I ever find a VG or NOS tank it will be back in that shape.....
No I said I wasnt sure, just going off a chart I have and not 100% sure its right. I will say that the part #s on it have been 100%.
Good thing I replied to you last night. :cool2:
You very well might be correct! Never had one apart.
It should look familiar, but I dont remember if thats the one you have or the one I kept. :hmm3grin2orange:
Black, red or yellow. :msp_wink: Have a NOS take off too in yellow I been saving to replace my cracked 415 tank. Been on the shelf awhile now.
Here we go again........Mine is just like the one in the picture...
I had used my black tank from my builder 425 to put on my 475. The scuffed yellow one might be going on the 475 and the NOS one might end up on my 415. Still have 2 505 builders with black tanks and 1 runner 505.
Yea a drill press and a wire brush. The bar was rusty and missng alot of paint, that is what I came up with. I sprayed it with a clear also.
rms61moparman
Addicted to ArboristSite
I had used my black tank from my builder 425 to put on my 475. The scuffed yellow one might be going on the 475 and the NOS one might end up on my 415. Still have 2 505 builders with black tanks and 1 runner 505.
Now THAT'S just MEAN right there!!!!!
Mike
It was a subtle hint to him I may never use the NOS tank on my 415 :msp_wink:. I can live with the crack where it is at (you guys seen it at the last 2 poulan gtg's). I just wasnt sure when I first got 415 and started setting extra tanks back. :msp_tongue:
She wont be cheap though. :msp_wink:
rms61moparman
Addicted to ArboristSite
I'll bet it will be cheaper than a ***** tank and go on a LOT better looking saw too!!!!!!!!!
Mike
Watcha ya talking about Willis. :msp_razz:
Still the only one I have seen with a yellow carb cover. Sold new at TSC this way. I'm 2nd owner. Bet it hasnt had 5 tanks through it. The original owner lost it under a tree 3rd time using it.
Dont know if you can see crack on floor of rear handle or not.
BEFORE as bought
AFTER
For Roger...
A compression release is a great idea. I wish I had one on several more of my saws...
