Warped5
WingNut
Looks like there may be damage above the studs in pic #4. He was careful to not get it in pic #3. Too much going on there for it to be a mere reflection.
Nik's Poulan Thread
- Thread starter FATGUY
- Start date
Help Support Arborist Forum:
Chris J.
Addicted to ArboristSite
The paint on the CC is what caught my eye, looks too new & too thick to me.
Looks like a hot spot to me where someone over heated the chain brake. As if they ran it with the brake on. Not only that but after looking at it again the clutch cover is a different color so I think it has been repainted also.
That cool looking. I got a 8" bar I was thinking about fitting up to one.
yeah. let's paint it. none of them dunces will ever notice. better to have left it original and let the buyer paint it. always makes me wonder what else someone is trying to hide.
Tractorsaw1
ArboristSite Guru
Anyone ever retro fit any cylinders or pistons on any of the 3400-8500 poulans? Ive tried searching, but I didn't come up with anything.
I have not seen it done..other than swapping parts from the same series to one another. But no hybrids or cross breeding.
Just looks like the chain pic that sticks out on clutch cover for folks to follow to me that goes across cover.
You can see it here too if you look close.
Here is a vid of the 3750. Still not broken in I only have about one tank through it so far. I did a check of the compression and got 160psi which is not bad for 6000 feet above sea level.
Just looks like the chain pic that sticks out on clutch cover for folks to follow to me that goes across cover.
You can see it here too if you look close.
Could be because of how the light is reflecting on it, but the color still looks different from the rest of the saw to me.
If you dont own the saw then you wont understand LOL only forgot a comma in the sentence. 
Just looks like the ( chain pic that sticks out on clutch cover for folks to follow ) to me, that goes across cover.
Just looks like the ( chain pic that sticks out on clutch cover for folks to follow ) to me, that goes across cover.
The paint on my clutch cover would look like the one in pic if taken up close with a flash. JMO.
You can see the 2 areas of raised chain above studs and brake back forth pic in O at brake handle area in this pic.
You can see the 2 areas of raised chain above studs and brake back forth pic in O at brake handle area in this pic.
That explains it well. I wasn't sure if it was my drinking or yours when I first read it.
Just having troubles with wording to make it to where anyone could understand. Without any knowledge of what the clutch cover looks likes up close.
Sometimes what I'm thinking and typing just dont sound right once done. Just like now LMAO
I concur!
Lee
Lee
Hope its OK to post it here, I just finished a PP395, Havent run it yet, i will tomorrow and post pics then. Id like to trade it for a 3750 or SP 380. Figured Id throw it up here first.
Last edited:
rms61moparman
Addicted to ArboristSite
Ain't no such critter Bob.
Rim drives run the same for 3/8ths and 3/8ths LP.
I looked for a WHILE for one until I asked the dealer.
Put the 3/8ths 7 on it and "away we go".
Mike
Similar threads
