Nik's Poulan Thread

[MS460WOODCHUCK]

Can any of you tell me where I can get a set of rings for a 4000? Part #530026003.

 

[echoshawn]

Can any of you tell me where I can get a set of rings for a 4000? Part #530026003.

NLA anywhere from my understanding. Few guys have extra sets floating around. I've been off of here a while. Not sure if anyone has found a close match that works with some grinding?

 

[67L36Driver]

I'm thinking strato. I know diddly about them. Need some advice

Check the four bolts that hold the engine in the chassis. They are often loose.

 

[MS460WOODCHUCK]

Does anyone know what size of rings for the 4000? The thickness and size of the piston?

 

[RedneckChainsawRepair]

Does anyone know what size of rings for the 4000? The thickness and size of the piston?

I've got all the info saved in a thread on CR. Cant say off the top of my head.

 

[RedneckChainsawRepair]

4218 IMO a good saw for what they were built for.

Change the OEM fuel line pronto = junk. Check the clear other ones too.

Sold this one for $60-$75 cant recall for sure which.

 

[RedneckChainsawRepair]

Does anyone know what size of rings for the 4000? The thickness and size of the piston?

Info bumped up so you can find easy. LOL . page 13 for ya. http://chainsawrepair.createaforum.com/poulan/poulan-4000/new/#new

 

[Acornhill]

Take a set of 4900 rings and cut down to fit. Or a set of homelite 540

Sent from my LG-D800 using Tapatalk

 

[Boomer 87]

The size 49mm is stuck in my mind in the 4000 bore dia

 

[RedneckChainsawRepair]

The size 49mm is stuck in my mind in the 4000 bore dia

Close in thread 49.2mm

 

[Boomer 87]

Ok I knew it was close. I went through all that once deciphering what I had. Comes out to about 1.937" I think

 

[Boomer 87]

I'm thinking strato. I know diddly about them. Need some advice

Yes they are stratocharged. In my experience there a little finicky to get tuned right, but once tuned there just fine firewood cutter. There every bit as good as a ms250....... gasp! Ya I went there

 

[Just a Guy that cuts wood]

Carb tuning from Wed. Last video Low 1 1/4 High 1 3/8

First vid now set 1 1/4

 

[Just a Guy that cuts wood]

cut 2 1 1/8
20160911 1650491 1.125

 

[Just a Guy that cuts wood]

Cut 3 1 turn out

 

[Just a Guy that cuts wood]

Cut 3 sounds better or is that to much ?

 

[Boomer 87]

It sounds way better than the original video you posted. Seems like the third video it was coming on and pulling hard

 

[Boomer 87]

It's alittle hard to say for sure just listening to it on a video. Some of the more experienced guys can pipe up.but I think cut 2 or 3 or in between 2-3 sounds pretty good

 

[p61 western]

Cut 3 sounds better or is that to much ?

What carb do you have on that saw,is it still the old pioneer carb 21-85?

 

[Just a Guy that cuts wood]

Felt good was thinking of trying 7/8 out
I am not sure what it should feel like sound like
20 years of running a grinder ( rod burner ) lost a lot in right ear