I get the same joy when I bring one back to life. Nothing like the first pop and you know it will run but you don't have any idea what else needs done. Enjoy the project and report back to us
Nik's Poulan Thread
- Thread starter FATGUY
- Start date
Help Support Arborist Forum:
Heading to the Upstate NY GTG this weekend. Taking one Canadian and two American built hot rods. Homelite XL-76, Poulan 5200 and a McCulloch CP125.
All three pretty special units.
All three pretty special units.
Have fun, but not too much, you still have to drive home. Just make sure what ever you drive that you have extra room for bring backs.
Steve
Steve
Be sure you send some pictures our way
WOW, that's a lot of parts. I may need to go visit my mother inlaw sooner.
Steve
Steve
Will do if I remember. The weather forecast changes drastically every 4 hours or so. It looks wet.
I go down Saturday, GTG on Sunday, stay over and head home Monday. Roughly an 8 hour drive each way.
Lots of fun. It really good to meet people on here face to face.
If any of you have a chance to get to one, you should make the effort.
I've made one every year since 2013,
I just wish they were a bit closer to home.
You got any rings and cylinder gaskets for a 4000?
Attachments
Could you tell me where and when GTG is happening in Upstate New York
Sent from my SM-G920V using Tapatalk
That is a nice stack of 4000
Those saws will wakeup the neighborhood at 6am.
Steve
Steve
s25
Never seen a red Mac
Steve
Steve
Brush bow
Steve
Steve
I took this poulan countervibe stuff in trade today to help a local get his parts he needed. Traded 380 3750 p+c and 22" badboy bar and new chain and a crankcase for his 3450.
The poulan 4000 has a 3400 rear handle on it do to the 4000 handle in pic was cracked and other half broken. The 4000 recoil pulley and recoil still good but he said the flywheel had a issue. So replaced with a 3400 flywheel and recoil cover.
Craftsman 3.7 was told runs but has a break you can see in rear handle at back L. 3400 just a part saw with clean looking piston.
Will sell or trade off to folks too.
The poulan 4000 has a 3400 rear handle on it do to the 4000 handle in pic was cracked and other half broken. The 4000 recoil pulley and recoil still good but he said the flywheel had a issue. So replaced with a 3400 flywheel and recoil cover.
Craftsman 3.7 was told runs but has a break you can see in rear handle at back L. 3400 just a part saw with clean looking piston.
Will sell or trade off to folks too.
For the folks asking in PM's. I will just post them all here.
3400 3.7/3800 4000
3400 3.7/3800 4000
Similar threads
