Trying to save an old 015 AV

[If_it_aint_broke]

Not a professional by any means. I just acquired an old 015 AV, and I'm in the process of rebuilding it. I'm used to 4 stroke engines, and have built a few. I have pretty good mechanical ability, and do all my own automotive work (and sell parts for a living). I thought I could just wing it with this rebuild, but that was a bad idea. I'm good with small engines, but 2 strokes are put together so differently that I made some serious mistakes. Broke the clutch because I didn't realize it was left hand thread (real idiot move there), thought it was just peened on and needed some "extra persuasion". And, when I split the crankcase, for some reason I expected to find a normal (for 4 strokes, anyway) rod bearing arrangement. To my surprise, I was met with a one-piece rod, and a bunch of little rollers. Moved it just a little bit and they all fell out...right into the dirt. I just found (finally), the service manual. Rest of my parts should be here today.

I'm also pretty new to using a chainsaw in general. My first experience was because of Helene. We got hit hard, and I mean HARD. Not as bad as NC, but we lost power (and water) for almost 3 weeks.

 

[stihlaficionado]

Welcome to AS

 

[Mad Professor]

Not a professional by any means. I just acquired an old 015 AV, and I'm in the process of rebuilding it. I'm used to 4 stroke engines, and have built a few. I have pretty good mechanical ability, and do all my own automotive work (and sell parts for a living). I thought I could just wing it with this rebuild, but that was a bad idea. I'm good with small engines, but 2 strokes are put together so differently that I made some serious mistakes. Broke the clutch because I didn't realize it was left hand thread (real idiot move there), thought it was just peened on and needed some "extra persuasion". And, when I split the crankcase, for some reason I expected to find a normal (for 4 strokes, anyway) rod bearing arrangement. To my surprise, I was met with a one-piece rod, and a bunch of little rollers. Moved it just a little bit and they all fell out...right into the dirt. I just found (finally), the service manual. Rest of my parts should be here today.

I'm also pretty new to using a chainsaw in general. My first experience was because of Helene. We got hit hard, and I mean HARD. Not as bad as NC, but we lost power (and water) for almost 3 weeks.

The 009-0015 are a strange bird, but not terrible saws.

As all saws left hand thread clutch. What did you break?

Rod bearings lower , are individual and the rod holds them in.

 

[If_it_aint_broke]

The 009-0015 are a strange bird, but not terrible saws.

As all saws left hand thread clutch. What did you break?

Rod bearings lower , are individual and the rod holds them in.

The nut part of the clutch collapsed. I should have known that but in the automotive world we rarely see left hand thread, so it just didn't occur to me. I thought it may have been a prevailing torque nut, and did not notice that it was part of the clutch itself, and not a separate nut.