The New MS880 AS Compared To An 088

[Mastermind]

I'm here now......

 

[Deets066]

How dems big ole hogs comin long?
Any fancy port work pics yet

 

[VinceGU05]

That was just a clearance I found given for a new Wisco piston......60mm

I think we are in good shape on skirt clearance.

i gotta NOS 084 piston here. need a measurement still?

 

[big t double]

i gotta NOS 084 piston here. need a measurement still?

Post it up!!!

 

[Mastermind]

I measured a NOS 084, 088, and a 880 piston.........all the same.

Not done yet.......close, but not quite finished. Remember, I was doing 4 jugs.

 

[Deets066]

Ya ever played with 4 jugs that big at once before?

 

[Mastermind]

Ya ever played with 4 jugs that big at once before?

Yeah.....but don't tell muh wife.

 

[Dieselshawn]

Mastermind: 185-190 psi compression? Anymore makes too much heat?
Diesel fuel should work good as a fuel instead of gas then.....

My logging buddies ran their 088 on diesel for 20 mins one time after the gas bar attendant accidently put that fuel in their saw can.....

Saw even smoked like a diesel....

Not quite as much power but it ran 20 mins with no issues.

Then they smelled the can.....

 

[lovetheoutdoors]

Randy would you prefer to port a 084, 088 or a 880?

 

[Mastermind]

Randy would you prefer to port a 084, 088 or a 880?

No real difference.

 

[lovetheoutdoors]

No real difference.

I know there all very similar. Wasnt sure if you got better gains from one more than the other.

 

[Mastermind]

The 084 is always the same......the 088/880 can be different. Coils, carbs, etc....

 

[Mastermind]

Keith's 088....

 

[Deets066]

 

[Mastermind]

I ordered you a new piston this morning Keith. It will be at the dealer tomorrow, and then will be sent on the me. I should have it in hand by the end of the week.

 

[295 tramp]

man that sure is purdy.
I chomping at the bit two see my pair.

 

[Mastermind]

They are boxed up.......ready to go.

The used jug is as slick as I can make it. The piston drops in with no resistance at all. The only thing that could be an issue with it is if the plating tries peeling above the exhaust. I don't really think it will though. Keep an eye on it for a few tanks........and keep me in the loop.

 

[big t double]

who in the hell's keith? hahaha

 

[Mastermind]

Some chit head.

 

[JBA]

Yeah.....but don't tell muh wife.

I don't tell my wife anything. She already knows too much about me. If she knew half of what I did in the past she would run away right now.