jeagan
ArboristSite Lurker
we be next
Partner Chainsaw Thread
- Thread starter Arrowhead
- Start date
Help Support Arborist Forum:
Piotr Pakuła
ArboristSite Guru
Has anyone tried to secure the hole under the clutch bearing in toasters? To reduce draft in the crankcase
You should leave that hole open. Its purpose is to lubricate the clutch bearing.
Piotr Pakuła
ArboristSite Guru
Other chainsaws do not have this hole
But yours does. It’s a designed in leak.Other chainsaws do not have this hole
Piotr Pakuła
ArboristSite Guru
I will try because there is no longer enough fuel for proper operation
jeagan
ArboristSite Lurker
If you have to plug that hole, then there is something else wrong that needs attention.
Piotr Pakuła
ArboristSite Guru
Crankshaft seals
Just change the seals and don't worry about the hole.
For a P100
FW side 15x26x7
Clutch side 20x40x7
Piotr Pakuła
ArboristSite Guru
These sealants are very hard to fit, corrosion holds them together. The outer side of the sealant is steel. I saw a set of pullers once, maybe someone can recommend some?
