Partner Chainsaw Thread

[jeagan]

we be next

 

[Piotr Pakuła]

Has anyone tried to secure the hole under the clutch bearing in toasters? To reduce draft in the crankcase

 

[av8or3]

Has anyone tried to secure the hole under the clutch bearing in toasters? To reduce draft in the crankcase

You should leave that hole open. Its purpose is to lubricate the clutch bearing.

 

[Piotr Pakuła]

You should leave that hole open. Its purpose is to lubricate the clutch bearing.

Other chainsaws do not have this hole

 

[av8or3]

Other chainsaws do not have this hole

But yours does. It’s a designed in leak.

 

[Piotr Pakuła]

But yours does. It’s a designed in leak.

I will try because there is no longer enough fuel for proper operation

 

[jeagan]

I will try because there is no longer enough fuel for proper operation

If you have to plug that hole, then there is something else wrong that needs attention.

 

[Piotr Pakuła]

If you have to plug that hole, then there is something else wrong that needs attention.

Crankshaft seals

 

[Modifiedmark]

Crankshaft seals

Just change the seals and don't worry about the hole.
For a P100
FW side 15x26x7
Clutch side 20x40x7

 

[Piotr Pakuła]

These sealants are very hard to fit, corrosion holds them together. The outer side of the sealant is steel. I saw a set of pullers once, maybe someone can recommend some?

 

[Modifiedmark]

Take a punch and drive the seal in just a bit to break it loose. Sometimes if i have room I use a tiny drill bit and drill a hole in the seal, then put a metal screw in it then pry it up and out.

 

[bob kern]

I suppose this item is unobtanium????? On my pro Mac 1000.

 

[Piotr Pakuła]

Take a punch and drive the seal in just a bit to break it loose. Sometimes if i have room I use a tiny drill bit and drill a hole in the seal, then put a metal screw in it then pry it up and out.

I'll try, but it seems that the metal ring is only on the outside and is thin, maybe I can screw it in