Hey, I have 3 of them ... one at home, one at the cabin and the third one stays in my truck! (I got the 3rd one very cheap - used, but like new). Guess not everyone likes them!One for each hand?
Hey, I have 3 of them ... one at home, one at the cabin and the third one stays in my truck! (I got the 3rd one very cheap - used, but like new). Guess not everyone likes them!One for each hand?
For Harold??Amateur Hour Saw Porting!
That is my HF deluxe pedal control grinder!
The 066 with the Cross cylinder is running so strong that I decided to get another one of my 660s running. This one is an Asian saw with a Meteor piston and I'm putting an OEM 066 (w/decomp) jug on it. The transfers looked good, but the intake was wider on top than on the bottom. Since most of the flow occurs when it first opened, I fixed that issue and may have even made the bottom a bit wider.
The exhaust port had good width, but (IMO) a bit too much arch on top. I still left a little and made sure I beveled it, but a flatter top will usually make more power.
The squish was a bit too tight, and no one seems to sell thin gasket material, so I made one out of an aluminum can. Hopefully I will get it running tomorrow. Today I spend too much time running around to stores I was told had .005 gasket material but did not.
Fingers crossed it runs strong and stays together.
Enter your email address to join: